Hi all,
geffric, have fun on the drive... I may get to see the movie later today ( if
RRBB will let me...
slo,
TagBabyIan is much smaller than Katrina, but I am sure he will eventually catch up... PD on the shots, and I'm Glad she is doing better!!!!!
DHMadamePresidentSsenior007, Congratulations!!!!! Not sure about Robots, looked more like a spoof of Futurama; not a big fan of that... Will wait for it on HBO!!!...when
TagBabyIan is asleep...Thanks for the review
Just need to blow off a little steam, mind if I soak in the M&M pool and rant for a bit???
[Rant]
Yesterday I had a rough day. I started out trying to configure some video equipment "In a manner which it is not designed to function" After about an hour I gave up and called the factory Support. Two hors later we had to dump everything we did and start over beause he didn't know that we needed to use an option for whate I wanted to do. I set it up "Close" to what I wanted, and called the camera installer backto re-engineer some cabling outside the box. I have not put RG59 connector on cables for about 15 years, so I didn't want to start now....OK, what is next?? well, there was this bad flicker on one of the monitors (on a different system). My boss says fix it now... What is bad? the calble connections are 15 years old (imagine that) but the person who did them (not me) made them a little loose, and they needed to be redone. I get my tool kit out, Pull the monitor, Make sure I have the connectors... OK, RG59 Plenum... Yup, I snip the wire and realize....It is RG59/U (it is a thicker wire and uses a diferent connector

.) OK, It is now almost 4:00PM, I get in my car to drive to the connector store, Get there, verify it is the riht connector, and speed back to my office. I dutifullu make the connector...The cable slides out. GRRRR..I cut the other side (which IS Plenum)... Same problem... I must be doing something wrong... It is now 5:45pm, the supply house closes at 6:30. I remembered where the signal lights were out by the supply house, so I took an alternate route... I got there at 6:15 (it is a half hour away, and I got lucky on the second trip) I walked up to the guy who usually helps me, and explained my problem...Cost is not an issue. I need some wire, Show me what I am doing wrong.. Well, after an hour the expert came over and he couldn't figure it out. The he realized the sample witr we were using was for Compression connectors and not Crimp Connectors. He got a sample of the kind of wire that is in my office, and it still took another 20 minutes to get it right. Time: 7:45, I paid for the supplies we used, bought a new crimping tool, some more connectors, and I call home..
RRBB was quite cranky and had already eaten... Stop at McDonalds (this location had WIFY!?!) and headed home knowing that I have to go in at 7:00am...
RRBB was not real happy with me..it was a little crankyness. I called a few times to let her know I would be late...) at any rate it is 6:30AM and I must get ready for work...
[/Rant]
