That was my original plan... But it says do not iron. It is polyester, I'm worried it would melt! Eek!
Sent from my iPad using DISBoards[/QUOTE]
Idk if this is too late to help you, but I saw on the Fb page that someone ironed it anyway. So I had DH unearth my iron (only use it a few times a year ROFL), and I dusted it off
and realized that there is a polyester setting! And I don't have an ironing board, let alone a sleeve-thingy, so I took a small cutting board (clean) and stuck that into each pocket as I ironed it. It still wasn't easy though.
Because when I unrolled my soon-to-be FE, one pocket was fine, but the middle and bottom were very wrinkly.
Also, I used just fabric markers for our names. (WARNING: Fabric Markers can BLEED!) I bought that Walmart Disney ribbon, the black background with the red and yellow Mickey Heads? And I ripped off the stripes that came on the pockets and glued the ribbon on with fabric glue. In hindsight, I probably could have left on one of the stripes because that black Mickey-head ribbon is barely wide enough to cover both sets of holes. It's definitely NOT wide enough to cover both rows of holes AND overlap the raw edge from where the lower stripe was. After I glued on the ribbon and let it sit overnight, I then went back over the thing and glued the under-flap where it stuck up a lot IMHO lol.
Then I found this "Wish Upon a Star" pewter charm in my stash and sewed it to the top.
I am trying to put the picture of it here
http://i931.photobucket.com/albums/ad160/Mom3girls2000/Ikea3PocketFE.jpg?t=1360035096