I finally found my lime green top and I think it'll do! It's a little unforgiving and clingy at the moment
but hopefully it'll look alright by September!

Thanks Marsha for your ideas/templates!

I think I'll make a couple of pins for DH and I to wear - only thing is, how would I go about doing this? I'm horribly uncrafty so all suggestions gratefully received...
?[/efore QUOTE]
If you have like a craft store nearby they probably like here sell plastic button cases. you pop to front and back off, put a picture in then pop them back together. the pin is already on there too.
if want to use the template i have let me know your email addy (private message me that) and I can send you the template on word document. in the PM if give me names, or what wording you want I will be happy to make the changes and then email template.
all you would do then is print. now printing you may have to play with depending on size of button you get. but again i can help out as much as possible shrinking or enlarging template to fit button.
what i did last time was one printed it really didn't fit or fill in the entire button case. so I printed it out, left more white background enough to fit button case. then i put little disney stickers around where the actual button design on that extra white background. that way the actual design alone with the stickers appeared to be the complete design and fit button size.
basically:
PM your email so I can send template.
in PM if want me to make changes with names etc... let me know
I will email template to you in attachment.
you print, cut out and place in button case.
find a craft like store
see if have plastic buttons that you snap the front/back off/on
put cut out design in button and snap back together.
if needed put little disney stickers to fill in space if design isn't as large as button.
make sense?