? for Marion about one of your designs??

[Our3ps]

Hi Marion,

I was hoping you could explain to me how you did this design? Specifically how the text is just behind the black of Mickey? Is it similar to the way name fills are done, with just a jpg of the text you would like to use written over and over? I just can't figure out how the text is only applied to a specific section. If it at all matters I use PSE11.

Name of your file. MickeyMyName1.jpg


Sorry if I shouldn't have started a new thread...I just wasn't sure where I should pose a question like this to you.

Thanks!

 

[RustManFan]

I made the text into a Pattern and then just used it to fill the black....I am no expert...I generally just experiment.

See elementsvillage.com for more expert advice on general How-Tos

and note that there is an Elements sticky at the top of the forum with other people learning techniques

 

[Our3ps]

Thanks!