Wishblade and Bazzill...not a good combination???

[graygables]

I'm getting ready to order my Wishblade, but need it specifically to cut Bazzill cardstock. Anyone have any experience with this? I'm just now finding out that there are/were some issues???

 

[RRBB]

I haven't cut Bazzill cardstock, yet. But I have cut through other heavy/dense cardstock. The trick is to run it through 2 or 3 times to get a good, clean cut. Basically set it to eject when finished but don't remove from the wishblade, then start the cutting over again. It will make the cuts, again, in the exact same places.

 

[GC&S]

I just got the WB and it cuts Bazzil with no problem. It tells you what setting it has to be on specifically for the bazzil. I've only had to run it through the cutter once.