I sent an email off tonight so I should get an answer tomorrow. I don't mind making a $1.50 purchase. I'm worried about putting this table together! I am not mechanically inclined at all
Table is pretty easy. Its that darn trash can I couldn't figure out at first.
Place bottom of table on the floor. (I like to have the handle facing me & not customer.)
Next take one of the support legs & bend it into a V -- with the slots facing up. Place into the table base.
Next take the other support legs & bend into into a V --with the slots facing down. Now turn it so the bottom of the V is at the top instead of the bottom. And slip this V into the other V.
Put top of table on -- again with handle hole facing you & not customers.
Viola. Practice a few times as home. Its not complicated. Written directions actually look worse. But sometimes it can be a bit clumsy to do.
I'll go back & see if I can find the written directions someone posted for the trash can...because I can't even explain that one. lol
Found it.
4/12/06 POST #226 by ZanneMarie.
Quote:
"Ok... I will try to explain how to assemble the trash can. You are right it does end up being six sides-not all equal sides but six of them. There are six flaps...one that is kinda U shaped, two identical triangles, two more similar triangles and then a single longer tab-like one. Hold the future trash can with the longer tab-like one closest to you. Fold in the U shaped one, follow with the first set of triange ones (both of them), then the second set of triangles (both of them) and then finally the single tab...push the tab all the way in and it will lock with the others. Then push down from the new inside of the trash can. Voila!! I could not make it fit in the base of my table but I did not try that hard. Hope that was clearer than mud!!" End quote.
I practiced this one at home a few times...and STIL took the directions with me. After a few times, it wasn't a problem anymore. Good luck.