I love the look of embossing powder but don't use it too often- lots of stuff to take out and use.
You use an embossing liquid and put it down where ou want the powder to be- I have a pad to stamp or use on a large area and a pen for small areas. Then you sprinkle the embossing powder onto the liquid and shake/tap off any extra- I have a little tool that will catch the powder and make it easier to put back into the container. Then you use a heat tool to melt down the powder. you can do it again over the powder for a different look or to add depth.
Sorry I meant to include the measurements. Here you go.
Sketch 4:
Red: 12x12
Present pattern: 4x12
Green: 4 1/2 x 6 1/2
Blue: 3 1/2 x 6 (one end is ripped)
Red stripe: 2 1/2 x 3 1/2
Gray: 3 x 4
Cany cane ribbon: 1/2 x 12
Top ribbon: 1/2 x 12
Ohhhhh.... I love it!!! You need the heat gun and powder and the special ink. You just stamp the image, sprinkle the powder, tap off the excess, heat and you are good to go!!!
You stamp with either ink or a moisture pad. The powder is very fine so it sticks to anything. It is pretty cool stuff. You just have to watch the heat gun...it gets very hot!
Our Authorized Disney Vacation Planners are here to provide personalized, expert advice, answer every question, and uncover the best discounts.
Let Dreams Unlimited Travel take care of all the details, so you can sit back, relax, and enjoy a stress-free vacation.