engineers out there or a QS

[paulh]

just trying to convert m3 to tonnage of MOT crush and run stone. i reckon i kneed to fill in 2.3 m3 and am assuming it will take around 1.8 tones per m3.so am getting 5 tone to be on safe side
Sorry girls if that went straight above your heads

 

[natalielongstaff]

Sorry girls if that went straight above your heads

Not at all, i totally understood it !!

 

[UKDEB]

Sorry girls if that went straight above your heads

Do you have a death wish?

 

[paulh]

Do you have a death wish?

now do you want be to join in GHD posts ?
Paulh

 

[Tink2312]

My Dad's a QS and the conversion factor seems about right so 5 tonnes seems a generous enough estimate just to be on the safe side.

I think you need to retract previous staement unless you want us girlies ganging up on you

 

[Goofyish]

MOT type 1 is 1.92 tons per cubic metre

 

[paulh]

MOT type 1 is 1.92 tons per cubic metre

now which are the best straighteners on the market timladies i beg your forgiveness
Paulh

 

[gemmybear83]

Sorry girls if that went straight above your heads

 

[Nubbedy]

Sorry girls if that went straight above your heads

LOL - it did!! But so does talk of GHDs - I don't know anything about those either - took me about 3 years to realise they were straighteners.

 

[paulh]

well i went for 4 ton in end as having to put down thicker insulation which has cost a fortune £650 well its the best stuff Kingspan Kooltherm K3 Floorboard.but why was the job i am on at the end and not the start,would have saved me a fortune and for the u value don't make a 55mm so have had to go to 75mm.well it will be nice and warm when done
Paulh