billwendy
DIS Veteran
- Joined
- Aug 28, 1999
- Messages
- 4,963
Ok- I have all my problems on page 17! You think I could be doing something wrong on any of the other pages to make this page not work? Like threading the needle wrong or the bobbin itself?
How is the thread supposed to be hanging out of the bobbin initially, so that the needle can draw it up anyway? Where it says on #2, to "Lighly draw up the needle thread, forming a loop"- the thread never comes up! And I mean never...... Is the thread supposed to be hanging out of the bobbin for it to grab or does it stay inside? Its confusing cause the bobbin goes in sideways, is this the same with every machine?
Thanks for any help!! I will try to post pics of what I mean later- DS is crying right now, so I gotta go for now.
Hmmm - frustrating !!! I have an old Kennmore and my bobbin also goes in sideways. I have to put it in a bobblin case, and pull the thread out a little and make it go through a groove leaving a tail hanging out. Then I make sure my needle is threaded, hold the end of the thread and turn my wheel to draw the bobbin thread up like a little loop. I usually use my scissors or something and just swipe it under the needle foot and it pulls the thread tails out. I really hope you can figure it out!!!
Teresa, you made me smile!!!
Daniel and company will be over in 5 hours!!!!!!!!! So excited!!!
