Jen this is the instructions I used , they were on the fish extender thread.
You need 1/4 yard of fabric, iron interfacing, wide double fold bias tape, and a 3/8" dowel 8" long.
Pockets are 11" X 5 1/2"
Back is 32" X 8"
Cut out backing and pockets then iron on interfacing.
Sew bias tape on top of pocket
pleat once on each side and pin bottom of pocket so that it is 8" wide.
baste, then pin bias tape on bottom and sew on
Pin pockets on backing and sew bottom of pocket to backing
Pin and baste around entire outside of project.
Pin then sew bias tape around outside edge of whole fish extender
fold top over leaving room for you dowel at top and sew along the inside of bias tape down each side to secure.
I didn't put interfacing on the pockets, and I didn't put the pleat in, I just cut the pocket to 8 in. I think the pockets are fine with out it.
Are you speaking a foreign language?



I no speak sewing. Looking forward to the pics!
