Wanted to share my stroller tags/license plates

[sbmock]

Thank you to all the wonderful designers who let us use their handiwork to make our vacations more magical. Here are my stroller tags and license plates that we are going to take to our first trip to WDW!!

I used the disney font and color matched each kids name to something in the photo.

I scaled the image to a 4x6 so I could just have them printed as a photo. There was a slight bit of distortion but I don't care and I don't really notice!

I had all 6 printed at target for just over a dollar total.

Then off to Office Depot to have them laminated. I cut the 'excess' off of the stroller tags (on the right) so that they were more dimensional. (*note the rounded corners and Daisy's arm)

I was a big spender and spring for the 10 mil lamination. It took 2 lamination sheets and my total was under $5.

I took them home and cut them out with 1/4" margin. Don't forget to round the corners because that thick lamination is SHARP! Holes punched throughout he 'screws' of the license and we are set to go!!

So for less than $6 I have BEAUTIFUL laminated tags for our stroller.

I have plans to get LARGE O rings that have the hinge on them and hang the licenses and stroller tags from the stroller handle. That way we can just flip the tags over on the O ring and that will let the kids know whose turn it is in the stroller!

Thanks again and I just had to share how another family has benefited from your generosity!

 

[noahdove]

You did a super job Enjoy your trip

 

[sbmock]

Thanks! I often wondered how other people printed theirs and how they attached them.

 

[miamimom2012]

thanks for posting... i always wondered what the finished product looked like ! great ideas too for the flipping of the tags !

 

[sbmock]

thanks for the feedback. Thanks for looking.