cuddlebug Nestabilities questions

[pink_fins]

Just got a cuddlebug a few weeks ago an purchased some spellbinders Nestabilities to use with it.

How do I set it up?

A plate
C plate
Nestabilitie
grey cushion (not sure what to call it)
then I add some scrap papers to fill in the rest so I can roll it.
does that sound right?

I tried putting B plate(instead of scrap papers) but it seemed tooo tight.


tia

gail

 

[rlovew]

I am not sure but I do know that if you really want to keep it even and perfectly aligned then you should get a magnet plate (available from spellbinder) and use that under the dies (with the dies cutting up).

Rebecca

 

[morgansmom2000]

Here's a blog post with instructions, Beate's blog. Have fun!

 

[disneynut14]

This is what spellbinders themselves recommends.

1. A plate
2. C plate
3. Spellbinders Die (cutting side or ridged side up)
4. Paper or cardstock
5. B plate
6. Run through Cuttlebug™ machine.

You would only need the mats if you were embossing. Then you would use this recipe.

1. Place A plate on bottom
2. Leave die face up on A plate with die cut still in the die.
3. Place one Spellbinders Tan Embossing Mat on top of the die.
4. Use 2 or 3 pieces of cardstock to shim. *Cautionary Note: Using more than 3 pieces of cardstock to shim Cuttlebug Embossing sandwich will result in B Plate breakage. When using Spellbinders Edgeabilities card making dies, shim with only 2 pieces of card stock.
5. Place two acrylic B plates on top of sandwich and run thru Cuttlebug machine to emboss Spellbinders die cuts.
6. Turn die over and use like a stencil with inks and chalks for added detail.

It may seem tight and sometimes you will even hear some cracking, but so far they work great in the cuttlebug.

Good luck.

 

[pink_fins]

Thanks all
Looking forward to doing it Now LOL

gail

 

[vanyel]

Thanks for asking the question as I was wondering too. Spellbinders are on sale at HL this week so I was thinking of trying them too.