I am trying to print pressed penny tube labels. Honestly, I started with these thinking they would be easiest, but clearly I am just not smart enough to figure this out!
I have m&m tubes that are about 3 1/2 inches high. I went into Natalie's photobucket account, clicked on the image, and saved it to my pictures. When I go to print it, using Photo Printing Wizard, it is either huge, or a certain size (3 1/2x5, 5x7) all of which are too big. I tried to insert it as a photo into a Word document, and I can get the right length (3 1/2 inches), but then the width is too small to fit around the whole tube and I can't adjust that-I don't know how and it would throw the ratio off and look distorted.
Can someone please, please tell me what I should be doing? I'm getting nervous since I want to make a ton of transfers, and if I can't do this, I'm sure I'll mess those up too
! Thanks!
I have m&m tubes that are about 3 1/2 inches high. I went into Natalie's photobucket account, clicked on the image, and saved it to my pictures. When I go to print it, using Photo Printing Wizard, it is either huge, or a certain size (3 1/2x5, 5x7) all of which are too big. I tried to insert it as a photo into a Word document, and I can get the right length (3 1/2 inches), but then the width is too small to fit around the whole tube and I can't adjust that-I don't know how and it would throw the ratio off and look distorted.
Can someone please, please tell me what I should be doing? I'm getting nervous since I want to make a ton of transfers, and if I can't do this, I'm sure I'll mess those up too
! Thanks!
