Discussion in 'Disney World Tips' started by jjohnson, Jun 26, 2006.
DS bought locks for his SW pins & I can not figure out how to use them. Could somone help? TIA
if you're talking about the little brass cylinder backs that attach to the pin, you get like 10 plus a tiny hex wrench, stick the wrench into the small black hole on side,and twist counterclockwise to loosen it, stick on pin,and reverse w/wrench to tighten- one tip, don't use these for pins your kid intends to trade every 10 steps... it takes too long to get them on and off, the good news is they really work,and you'll never lose another pin with these!
We became big fans of the pin locks on our last trip. We lost five pins in about an hour and then invested in the locks. A lovely CM at the Sorcerer's hat in MGM helped me lock my DS's lanyard pins while DD did her Stitch impersonation with another CM. The whole process took about 5 minutes, and we were so grateful. Here's how I was taught:
Your locks came with a small allen wrench thingy (sorry for the lack of proper tool lingo). You have to put place the pin on a level surface, put the lock on the pin with the side that has the small black side hole for the wrench DOWN FIRST, and then place the wrench (either side works - long or short length) in the small hole and tighten by rotating the wrench to the right. It does work best if you lay the pin flat and then put the back on.
After a while you'll get the hang of it and be able to take the locks off while holding a Dole Whip in one hand and pointing to a CM's lanyard with the other. Wait... At least it seems like I could do it that easily. I hope this makes a little sense! I have a pin in front of me and it's still hard to explain! Good luck!
We get it now & they work great! Thank you so much
Separate names with a comma.