Buffalo Airport directions needed.

Discussion in 'Canadian Trip Planning & Community Board' started by Tink42, Mar 7, 2001.

  1. Tink42

    Tink42 Mouseketeer

    Joined:
    May 15, 2000
    Messages:
    267
    I need some help. We are going to the Buffalo Airport from the QEW. I was looking at a map trying to figure out the best way to go. Should we cross at the Queenston/Lewiston(?) bridge get on to #190 and then I'm not sure how to get over to the airport. Any help would be appreciated.

    Thanks,

    Tink42
     
  2. lawgs

    lawgs DIS Veteran

    Joined:
    Aug 2, 2000
    Messages:
    2,672
    go over the peace bridge...

    just after you past customs on the USA side....go right but straight forward.....this takes you on to the thruway ramp (190 i think).....which you then take until you see the signs for albany or erie...

    you want to go left ....towards albany and the airport.......

    the airport exit is just beyond the walden ave exit....and is RTE 33 exit....this takes you directly into the airport (crossing genesee avenue)....just follow the signage...

    it is about 20 minutes from the bridge to the airport on a good day...

    [This message was edited by lawgs on 03-07-01 at 09:24 PM.]
     
  3. Tink42

    Tink42 Mouseketeer

    Joined:
    May 15, 2000
    Messages:
    267
    Thanks so much for your quick reply. We leave tonight for Buffalo.

    Sounds like it's pretty easy.

    Tink42
     

Share This Page