The DIS Discussion Forums - DISboards.com

The DIS Discussion Forums - DISboards.com (http://www.disboards.com/index.php)
-   Scrapbooking (http://www.disboards.com/forumdisplay.php?f=123)
-   -   using transparencies-is this right? (http://www.disboards.com/showthread.php?t=1038476)

disney funseeker 02-22-2006 10:14 PM

using transparencies-is this right?
 
First I need the correct transparency that will work in my printer.

Print on the rough side.

The smooth side is the acid free side, therefore the rough side is face up.

If I'm not using a brad to hold it in place, should I use vellum tape?

Stephres 02-23-2006 07:04 AM

It depends on what kind of printer you have. The transparency will tell you which side to use depending on the printer. Ink jets print on a different side than laser. I use brads and eyelets to hold in place. Or I tuck it partly under another element and fasten it down under there. Hope that makes sense!

piratesmate 02-23-2006 07:44 AM

What Stephres said......

I've also attached it with a die cut that I've run through my Xyron. Or just used a piece of regular adhesive & covered it with a die cut or sticker or button or....

Twigs 02-23-2006 09:25 AM

The transparencies that I have have a strip label on the top that you remove after printing, it tells which side to use for a lasar printer and which side for an ink jet printer. I use brads or eyelets too, but I have used the vellum tape adhesive. It does show a little, so I put a small strip behind any writing or behind the image that I printed.


All times are GMT -5. The time now is 03:29 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.

Copyright 1997-2014, Werner Technologies, LLC. All Rights Reserved.